![]() ![]() Replace silica gel packet and secure the lid tightly. As foil reaches the edge of the tub, press around the inside perimeter, keeping the excess foil up. ![]() PRESERVING FLEX PASTE: After each use, press the foil onto the center of the remaining material and continue pressing outward so the foil remains in contact with the material. FLEX PASTE cures in 24 to 48 hours and gets stronger over time.ĬLEAN UP: Use a cloth with mineral spirits or acetone to clean your tools and work area. Allow each coat to dry before applying additional coats. Always make sure all cracks & holes have been completely filled & cured before testing.ĭRY TIME: FLEX PASTE begins to cure once exposed to air, moisture & humidity and will skin in 15 to 30 minutes.Sanding is not recommended, instead smooth to desired finish or add designs to create unique artistic textures.Etching the surface will increase adhesion.Apply a generous amount to the surface using a smooth motion.Do not scoop deeply into the tub as this may create air pockets.Using putty knife, trowel or similar tool, remove an even layer from the top surface.Do not discard foil or silica gel packet! Remove silica gel packet and slowly lift protective foil from the surface. Surface must be free of grease, oil & dirt. Click here for helpful hints and instructions on how to properly use Flex Paste.ĭIRECTIONS: Protective clothing & eyewear are recommended.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |